Clarke 6499680 매뉴얼 - 페이지 2

{카테고리_이름} Clarke 6499680에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 6499680 2 페이지. Fuel transfer pump

ASSEMBLY

FITTING THE PUMP TO A BARREL

1. Assemble the pump as shown above. Use PTFE tape (not supplied) at all connections

2. Screw the threaded collar into the opening of the barrel.

3. Tighten the collar bolt to the pump body.

USING THE PUMP

1. Make sure all connections are secure and place a suitable container under the spout.

2. Pump the handle to draw fluid from the barrel.

• The first time you use the pump, liquid should begin flowing after several pumps of the handle

CLEANING THE FILTER

1. Remove the four bolts that connect the Inlet to the pump.

2. Remove the filter holder and filter.

3. Wash the filter of any contaminants.

4. Replace the filter holder and filter.

5. Reattach the Inlet and secure with the four bolts.

CAUTION: DO NOT USE THE PUMP IF THE FILTER. IS DAMAGED OR

BLOCKED.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

WHAT IS SUPPLIED

ASSEMBLED