Clarke 7120315 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke 7120315에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7120315 16 페이지. Cpe water pump
Clarke 7120315에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (17 페이지)

페이지 인쇄

Electrical Connection

Before connecting the pump, check the voltage and phase supply required, this information

can be found on the junction box cover on top of the motor.

Installation should be carried out by a qualified electrician, using I.E.E approved cable and

fittings, and in accordance with I.E.E. Regulations. However, in the further interests of safety

we would emphasise the following,

Wiring Connections For Single Phase Models

Single phase pumps should be connected to a standard domestic 13 amp, 230 volt (50Hz),

electrical supply, we strongly recommend that the connection be made via a suitable

isolator switch and Residual Current Device (RCD).

IMPORTANT: Should the supply be taken from a normal 13 amp socket, then the plug used

must be to BS 1363 standard, and the wires should be wired up in accordance with the

following colour code:

Green & Yellow ............... Earth or marked with a letter "E" or Earth symbol "

Blue ................................... Neutral or terminal marked with a letter "N"

Brown ............................... Live or terminal marked with a letter "L"

Wiring Connections For Three Phase Models

Again installation should be carried out by a qualified electrician, using I.E.E cable and

fittings, and in accordance with I.E.E Regulations. To connect the cable to the motor see

electrical connections inside the terminal cover.

Delta Connection

IF IN ANY DOUBT, contact CLARKE International Service on 020 8988 7400

WARNING: THIS PUMP MUST BE EARTHED.

Connections Within Terminal Box

Star Connection

-6-