Directed Electronics 560T 소유자 매뉴얼 - 페이지 14

{카테고리_이름} Directed Electronics 560T에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 560T 17 페이지. Remote start system

l l e e a a r r n n i i n n g g t t r r a a n n s s m m i i t t t t e e r r

The system comes with one transmitter. The receiver can store

up to 4 different transmitter codes in memory. Use the following

to learn the transmitter or to add a transmitter to the system.

The following is the basic sequence of steps to remember whenever

programming this unit:

2. P P r r o o g g r r a a m m . . After 5-seconds, press and hold both buttons on

the transmitter, until—(see step 3).

3. P P a a r r k k i i n n g g L L i i g g h h t t s s F F l l a a s s h h . . The parking lights will flash twice to

acknowledge programming of this transmitter.

To add a second transmitter (within 5-seconds of the first trans-

mitter parking light flash learn acknowledgment):

1. K K e e y y . . Turn the ignition to the ON position.

note: The system can only learn, after

being connected and with the FIRST

IGNITION ON. If not learned with

the first ignition on the battery will

have to be disconnected and then

reconnected and the procedure

repeated.