Clarke 7150710 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke 7150710에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7150710 13 페이지. Bore hole pump

SETUP AND OPERATION

This bore hole pump is designed to pump soft water from bore holes, wells,

underground springs or storage tanks to supply single sprinkler or irrigation

systems. The pump is watertight and must be submerged in water (max depth

15m).

Suitable pumping liquids are:

• Clear water

• Rain water

The pump must NOT be used to pump:

• Salt water

• Liquid foods

• Corrosive or chemical substances

• Flammable, explosive or volatile liquids

• Sandy or abrasive liquids

• Sewerage

• Liquids containing textile materials or paper fragments

SETUP

Attach the delivery pipe to the delivery port.

NOTE: DO NOT install a non-return valve on the pump delivery side as one is

already built into the pump. The non-return valve prevents the pump from

draining when stopped.

Secure the supply cable to the delivery pipe.

Secure the rope and lower the pump into the bore hole.

NOTE: The rope should bare the weight of the pump, NOT the delivery pipe or

the supply cable.

The pump must be positioned at least one metre above the bottom of the

bore hole. Sand and other material found in pumped liquid will cause rapid

deterioration of the pump and reduce its efficiency.

Before starting the pump, make sure that the delivery pipe is unobstructed

and the delivery port is open.

To start the pump insert the plug into the mains supply:- to stop the pump

remove the plug from the supply.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]