Clarke 7230024 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke 7230024에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7230024 13 페이지. Submersible pump

3. Do not use the pump if the water is liable to freeze as this can damage the

pump. Remove the pump from the water and store it in a frost free

location.

4. Inspect the pump regularly to check that the base inlet is clear of leaves or

other debris. Any blockage of mud or leaves can be cleared by washing

the pump in fresh water, or by using a garden hose to flush fresh water

back through the pump outlet connector.

5. Never switch on the pump with the outlet connected to the mains water

supply. The mud pack (item 2) and screen/filter (item 6) can be removed

for cleaning if necessary. Remove the mud pack (3 screws around the

base), followed by the screen/filter (3 more screws) if necessary.

6. Keep watch and do not allow the pump to run dry.

• When fitted (Hippo 2A), the float switch will turn off the pump when the

water level drops to a low level.

7. When pumping is finished, disconnect the pump from the power supply.

MAINTENANCE

WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT

IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,

ENSURE THE CIRCUIT BREAKER IS OPEN.

This pump should require no maintenance other

than regular cleaning. If the pump starts to show

signs of wear or damage contact the Clarke

service department for advice. Do not use the

pump if there is any damage to the mains supply

cable. Do not attempt to repair the pump yourself

(other than to replace those parts listed below), as

you may invalidate your guarantee and damage

the waterproof seal of the pump.

To fit a new power lead, remove the two screws

and the retaining plate from around the power

lead connector plug and pull the plug from its

socket.

When replacing, the plug must be sealed using a

clear silicon sealant. Apply the sealant to the body

of the connector plug as shown in the diagram,

before inserting it into its socket and replacing the retaining plate and screws.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]