Clarke 7230600 운영 및 유지보수 지침 매뉴얼 - 페이지 2

{카테고리_이름} Clarke 7230600에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7230600 17 페이지. Submersible water pumps

페이지 인쇄
Clarke 7230600 운영 및 유지보수 지침 매뉴얼
INTRODUCTION
Thank you for purchasing this CLARKE Submersible Water Pump. CSE pumps
are designed for pumping clean water only and will pump down to a water
level of 20mm.
This pump is designed for pumping clean water or water containing solids in
suspension and is ideally suited for draining ponds, pools, sumps etc. It is not
designed for pumping slurry, sludge, mud or heavily polluted water, or any
water containing chemicals or other acidic contaminants including salt water.
Pumps fitted with float switches are suitable for permanent or semi-permanent
installations where it is necessary to maintain water at a particular level.
As the water level rises, the float switch will rise and start the pump. As the
water level falls, so will the float switch until it stops the pump. Float switches
are factory set to provide the correct on/off switching mode, however, you
can adjust the level at which the pump cuts out by sliding the float switch
cable in its clip attached to the handle, to either shorten or lengthen as
required. The shorter the cable, the earlier it will cut out and therefore, the
deeper the water will remain at this point.

PUMP SPECIFICATION

Dimensions excluding
the elbow
Weight
Cable Size
Max. Capacity
Head Max
Motor Output
Outlet Diameter
S
CSE2
CSD3
140 x
149 x
302mm
400mm
4.3kg
8.0 kg
10 x 0.75
15 x 1.0 (m
2
(m x mm
)
x mm
253 L/min
95 L/min
10 m
45 m
750 W
900 W
¼
1"/ 25mm
1
"/
32mm
2
CSV1A
143 x
300mm
4.6 kg
10 x 0.75
2
2
)
(m x mm
)
118 L/min
5 m
330 W
¼
1
"/
32mm
CSV2A
143 x
335mm
5.6 kg
10 x 0.75
2
(m x mm
)
236 L/min
9 m
650 W
¼
1
"/
32mm