Clarke 7230604 운영 및 유지보수 지침 매뉴얼 - 페이지 3

{카테고리_이름} Clarke 7230604에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 7230604 13 페이지. 1300w submersible pump

Clarke 7230604 운영 및 유지보수 지침 매뉴얼

SAFETY INSTRUCTIONS

GENERAL
1. Read all instructions before use
and save these instructions for
future use.
2. An approved residual current
device (RCD) which has a
tripping current of less then 30mA
MUST be used for all operations.
3. The electrical supply must be the
same as that on the rating plate.
4. ALWAYS make sure that your
hands are dry when connecting
or disconnecting from the mains
supply.
5. NEVER pull the mains lead to
disconnect the pump from the
mains socket.
6. The mains plug must be kept
away from the water at all times.
7. DO NOT allow children or
unauthorised people to touch the
pump, cables or connections.
8. Disconnect the pump from the
mains supply when not in use.
9. If necessary have the pump
repaired by a qualified person.
10. Keep the mains lead away from
heat, oil and sharp edges.
11. If you have to use an extension
lead with this product, it must be
designed for outdoor use and
incorporate a cable suitable for
use with Class I appliances.
12. Disconnect the pump from the
electrical supply and wear gloves
during servicing or maintenance.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

PUMP SPECIFIC

1. DO NOT pump explosive /
flammable liquids or chemicals.
2. NEVER allow the pump to run dry
or operate out of the water.
3. Submersible pumps should always
be submerged and stored
vertically.
4. Disconnect the pump from the
mains supply before placing it
into or removing it from the water.
5. ALWAYS check the plug, and all
cables for damage before use.
6. DO NOT use the pump if
damaged. Refer to qualified
service personnel for repair.
7. NEVER carry or lowerthe pump by
the power cable or float switch
always use the handle or a rope
tied securely to the handle.
8. NEVER insert your fingers into the
pump whilst it is connected to the
mains.
9. Never use the submersible pump
in a swimming pool when there
are people or animals in the pool.
10. Keep the pump clear of any
sediment by standing it on a
platform or brick or suspending it
at a suitable depth.
11. DO NOT use the pump if the
water is liable to freeze, as this
can cause damage to the pump.
Remove the pump from the
water and store it in a frost free
location.
3