Acora Acoustics SRS 소유자 매뉴얼 - 페이지 3

{카테고리_이름} Acora Acoustics SRS에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acora Acoustics SRS 4 페이지.

Unpacking and Initial Placement

Each Acora Acoustics product has been inspected and packaged with pride.

Please verify that both crates are in good condition.

1) Remove the stand from the carton by removing the 4 clips at the bottom edges of the

carton (see below), then lift the top straight up and off.

2) Grasp the stand either by the speaker platform or the base and lift out of the bottom.

3) Visually inspect the stand for any transit damage.

4) Place the stands on level flooring and use the furniture sliders as you position them.

5) For initial positioning, place the speakers per their instructions

6) Connect your speakers to your amplifier and perform initial listening tests. This very well

may not be their final position.

7) Once you believe placement is set, remove the furniture sliders. If on carpet, also

remove the acorn nuts concealing the spike tips (caution, tips are sharp). The spikes will

also allow you to ensure the speakers are level. If the speakers are not level, unscrew

and remove the spike cap. This will expose the top of the spike. Using a flat head driver,

adjust the spikes until the speaker is level and stable (it should not rock from back to front

or side to side).

8) Once level and stable, replace the spike caps and tighten them.

Listen and enjoy. You may find over time that you want to re-adjust speaker placement,

again, please do not attempt this alone.

1) Pinch the two vertical ribs so the bottom

swings out from the base.

2 Swing the paddle up and pull entire clip

out when it becomes free.

3) Save these clips for future use