Alemite 8700 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Alemite 8700에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 8700 9 페이지. High-pressure hydraulic pump

SER 8700

24. Install the outer component assembly onto the inner

assembly.

• Use a slight twisting motion to pass the Seal.

• At the same time thread the Adapter into the base of

the hydraulic motor.

IMPORTANT: Make sure the flange portion

of the Adapter seats flush against the base of

the air motor. Should a gap exist, inspect the

components of the air motor packing group.

25. Install Stop Washer (23) into the Extension.

26. Install and seat Seal (24) [heel end first] into Valve

Body (25).

27. Install the Valve Body assembly (Seal first) onto

Primer Rod (27).

• Make sure the Valve Body assembly seats properly

in the Extension.

28. Install Follower Tube (31) over the outer tube

assembly.

29. Install O-Ring (32) onto Primer Body (33).

Loctite, 222, and 242 are trademarks of Henkel Corporation in the U.S. and elsewhere. ®

Trademark Office.

Revision (2-13)

30. Install and seat Valve Seat (26) [large diameter first]

into the Primer Body.

31. Install and seat Gasket (4) into the Primer Body.

32. Screw the Primer Body onto the Extension.

33. Place a large wrench or other suitable tool into the slot

of the Primer Body.

• Tighten all the components of the assembly securely.

• Crush all Gaskets.

34. Extend Primer Rod (27) from the Primer Body.

35. Install Primer Disc (29) onto the Primer Rod.

36. Gently screw Nut (30) onto the Primer Rod.

• Use an appropriate size punch in the hole of the

Primer Rod to prevent rotation. See Figure 2.

• Do not overtighten.

denotes a trademark registered in the U.S. Patent and

High-Pressure Hydraulic Pump

Alemite LLC