Alemite 8702-A 서비스 매뉴얼 - 페이지 7

{카테고리_이름} Alemite 8702-A에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 8702-A 12 페이지. High-pressure hydraulic pump

페이지 인쇄

High-Pressure Hydraulic Pump

Refer to Figure 2 Parts List

for Parts Identification

Figure 4 Pump Tubes 337384-H1, -D1, and -E1 - Section View

Alemite LLC

8. Install Pin (30).

9. Screw Rod (10) into Coupling (11)

until the pin holes align.

• Install Pin ( 9 ).

10. Screw Coupling (7) [center hole

first] onto the Rod until the pin

holes align.

• Install additional Pin ( 9 ).

11. Secure the hydraulic motor

assembly in a soft-jaw vise.

12. Screw the Coupling assembly onto

the hydraulic motor rod until the

pin holes align.

• Install Pin ( 8 ).

Pump Tube (Outer Components)

13. Install and seat Seal (21) [lips first]

into the bottom of Retainer (20).

See Figure 2.

14. Install and seat Bearing (22) into

the bottom of the Retainer.

15. Install Gasket (23) onto the top of

Extension (24).

16. Screw the Extension (Gasket end

first) into the bottom of the

Retainer.

• Do not tighten at this time.

17. Install Gasket (6) into the top of

the Retainer.

18. Install and seat Bearing (19) [small

diameter first] and additional

Gasket (6) into the top of the

Retainer.

19. Screw Tube (18) into the top of the

Retainer.

• Do not tighten at this time.

20. Install and seat Gasket (6) into

Adapter (5).

I M P O R TA N T: I f a

primer is used with Loc-

tite 222, the curing time

is greatly reduced.

SER 8702

Revision (1-10)