Clarke CFT230 설치 및 운영 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CFT230에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CFT230 13 페이지. Fuel transfer pump

INSTALLATION

Firmly screw the inlet adapter provided

into the inlet port, ensuring it is adequately

sealed.

Attach an inlet hose (not supplied) using a

worm drive clip, or similar, ensuring the

joint is airtight. The Inlet port has an arrow

embossed on the housing showing the

direction of flow.

NOTE:

1. It is important that the inlet hose is

completely free of holes or other

imperfections, otherwise the pump will

not operate satisfactorily or may not

operate at all.

2. The length of hose must not be greater

than 7metres which is the

maximum suction height

for the pump.

Before screwing on the outlet

hose for the first time, it is

necessary to prime the inlet

side of the pump, by pouring

diesel fuel into the outlet port

until all air has been expelled. It will not be necessary to carry out this

procedure again, unless the inlet hose has been drained.

Screw the outlet hose to the outlet adapter and the other end to the nozzle

assembly.

WARNING: Ensure the ON/OFF switch, located at the rear of the pump, is set to

the OFF (O) position BEFORE connecting the pump to the electrical supply.

This is to avoid the possibility of arcing taking place and thereby reducing the

risk of fire.

CFT 230

Connect the mains lead to the electrical supply, bearing in mind the warning

above, and set the switch at the rear of the pump, to the ON (I) position. The

pump will operate and pumping will begin.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]