Clarke CPE30A1 운영 및 유지보수 지침 매뉴얼 - 페이지 6
{카테고리_이름} Clarke CPE30A1에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CPE30A1 17 페이지. Cpe water pump
Clarke CPE30A1에 대해서도 마찬가지입니다: 운영 및 유지보수 지침 매뉴얼 (16 페이지)
페이지 인쇄
ELECTRICAL CONNECTIONS
WARNING! READ THESE ELECTRICAL SAFETY INSTRUCTIONS
THOROUGHLY BEFORE CONNECTING THE PRODUCT TO THE
MAINS SUPPLY.
Before switching the pump on, make sure that the
voltage of your electricity supply is the same as that
indicated on the rating plate or on the junction box
cover on top of the motor. This product is designed
to operate on 230VAC 50Hz. Connecting it to any
other power source may cause damage.
Installation should be carried out by a qualified
electrician, using I.E.E approved cable and fittings,
and in accordance with I.E.E. Regulations. However,
in the further interests of safety we would emphasise
the electrical hazard
.
WARNING: WIRES IN THE MAINS LEAD ARE COLOURED IN
ACCORDANCE WITH THE FOLLOWING CODE:
GREEN/YELLOW = EARTH, BLUE = NEUTRAL, BROWN = LIVE.
• The BLUE wire must be
connected to the
terminal marked N or
coloured black.
• The BROWN wire must
be connected to the
terminal marked L or
coloured red.
• The YELLOW AND
GREEN wire must be
connected to the
terminal marked E
or
or coloured green.
We strongly recommend that this machine is connected to the mains supply
via a Residual Current Device (RCD).
If in any doubt, consult a qualified electrician. DO NOT attempt any
connections yourself.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
Plug must be BS1363/A approved.
Earth
(Green and
Yellow)
Neutral
(Blue)
Ensure that the outer sheath of
the cable is firmly held by the clamp
6
Always fit
a 13 Amp
fuse.
Live
(Brown)