Clarke CSE400A 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke CSE400A에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CSE400A 13 페이지. Submersible
Clarke CSE400A에 대해서도 마찬가지입니다: 운영 및 유지보수 매뉴얼 (7 페이지)

페이지 인쇄

MAINTENANCE

WARNING: BEFORE CHECKING THE CONDITION OF THE PUMP, ENSURE IT

IS UNPLUGGED FROM THE MAINS SUPPLY. IF THE UNIT IS HARD WIRED,

ENSURE THE CIRCUIT BREAKER IS OPEN.

This pump should require no maintenance other than regular cleaning.

If the pump starts to show signs of wear or damage, contact your CLARKE

dealer for advice. Do not use the pump if there is any damage to the mains

supply cable, or to the float switch or its cable.

CLEANING

1. Check the pump installation regularly to ensure the water inlet is clear of

leaves or other debris.

2. Take extra care to remove any debris from around the impeller.

NOTE: Do not attempt to repair the pump yourself, as you may damage the

waterproof seal and invalidate your guarantee. Repairs must be

carried out by your CLARKE dealer, or contact the CLARKE Service

Department, on 020 8988 7400.

Note that the pump is fitted with an automatic thermal overload protection

device. If the pump overheats due to an obstruction in the pump, or pumping

warm water in excess of 35

the pump OFF and disconnect from the mains supply. Check for blockages

and allow the motor to cool (at least 15 minutes) before attempting to restart.

NOTE: If the pump becomes badly clogged, back flush by removing the

outlet hose adapter and directing a jet of clean water through the

outlet port.

STORAGE

When the pump is not being used for extended periods, clean and dry it

thoroughly and store in indoors. if the pump is left in water, it should be run at

least once a week to prevent it from seizing up.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

C for example, it will shut off automatically. Switch