Clarke CWP200 운영 및 유지보수 지침 매뉴얼 - 페이지 6

{카테고리_이름} Clarke CWP200에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke CWP200 13 페이지. Submersible clean water pump

INSTALLING THE PUMP

Remove all packaging and make sure that the pump has no visible damage.

Dispose of all packaging appropriately.

FITTING THE ELBOW

1. Screw one elbow into the outlet

port as shown. Three elbows are

supplied;

• Threaded elbow

• 2 x Push-fit elbow

2. Connect a suitable hose (not

supplied) to the elbow using either

the screwed end or push-fit.

3. When push fitting the hose to the

adaptor or elbow, use a jubilee clip and check it is secure. Do not

overtighten.

• Hoses to suit each of the above adaptor sizes are all readily available

from your local Clarke dealer.

FITTING THE MULTI-STEP ADAPTER

The stepped hose adaptor supplied is designed to be used for either screw

type hose connection or push fit.

• The multi step adapter will suit 1" (25mm) and ¾"(20mm) BSP hoses.

1. Screw the adaptor into the

threaded elbow and connect a

suitable hose (not supplied).

• The adaptor can be cut off

with a hacksaw to provide

clearance if required, when a

larger hose is to be used.

2. Trim the adaptor to size if required.

• Reducing the hose diameter

will affect the maximum flow

rate.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]