Directed Electronics WASP 718W 소유자 매뉴얼 - 페이지 12
{카테고리_이름} Directed Electronics WASP 718W에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics WASP 718W 20 페이지. Dei wasp 718w: owners guide
페이지 인쇄Adjusting the Shock Sensor Full Trigger
1.
Arm the system by pressing
2.
Within five seconds, press and hold
until the unit generates a long chirp.
3.
Release
on the transmitter.
To Test and Adjust the Current Full Trigger Setting
Strike the vehicle to test the current setting. If the impact is
detected the unit will chirp three or four times.
If the current setting is acceptable do nothing and the unit
will exit shock sensor adjustment mode.
If the current setting is unacceptable press
the sensitivity or
is pressed, the unit will emit one chirp and the sensitiv-
ity is decreased one step. Each time
will emit two chirps and the sensitivity will be increased one
step. There are 16 possible settings. When the maximum set-
ting is achieved, the siren will emit two short chirps followed
by a long chirp. When the minimum setting (full trigger off)
is achieved, the siren will emit one short chirp followed by a
long chirp.
NOTE: If more than five seconds elapse without an adjustment, shock
sensor adjustment mode will be exited. Repeat steps 1 through 3 to make
additional adjustments. The siren will generate one long chirp followed
by two short chirps when the shock sensor adjustment mode is exited.
8
on your transmitter .
on the transmitter
to increase the sensitivity. Each time
is pressed, the unit
1999 Directed Electronics, Inc.
©
to decrease