Directed Electronics 410 소유자 매뉴얼 - 페이지 11

{카테고리_이름} Directed Electronics 410에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 410 20 페이지. Dei automate 410: owners guide
Directed Electronics 410에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄

Disarming/Unlocking

To disarm the system and unlock the doors of the vehicle, press

for one second. The Failsafe® Starter Kill will be deactivated

and the vehicle's horn (if connected) will honk twice. The parking

lights will also flash twice (if connected). The red LED will go out,

unless the system is programmed for passive mode. If programmed

for passive mode, the LED will begin to flash rapidly when the sys-

tem is disarmed. This indicates that the system will re-engage the

Failsafe® Starter Kill relay and re-lock the doors (if passive locking

is selected) in 30 seconds unless the key is turned on.

NOTE: If the system has been armed with the remote transmitter, you

must use the transmitter or the Valet switch to disarm the system and

deactivate the starter kill. Manually unlocking the vehicle does not dis-

arm the system; it will only unlock the doors.

Disarming the Failsafe® Starter Kill without a Transmitter

This feature allows you to override the starter kill without the

transmitter should it be lost, damaged or disabled. To do this, you

must have the ignition key and know where the Valet® switch is

located. Check with the installer for the location of the Valet® switch.

Turn the ignition to the "run"

position. Press and release the

Valet® switch, within 10 seconds.

The LED will stop flashing and the

vehicle should start. If it does not,

you may have waited too long.

Turn the ignition off and try again.

1999 Directed Electronics, Inc.

DRW-35