Directed Electronics 410 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Directed Electronics 410에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 410 20 페이지. Dei automate 410: owners guide
Directed Electronics 410에 대해서도 마찬가지입니다: 소유자 매뉴얼 (20 페이지)

페이지 인쇄

1. Programming Options

Disarming the Failsafe® Starter Kill without a Transmitter

This feature allows you to override the Starter Kill without the trans-

mitter should it be lost, damaged or disabled. To do this, you must

have the vehicle's ignition key and know where the Valet® switch is

located. Check with the installer for the location of the Valet® switch.

Turn the ignition to the "run" position.

Press and release the Valet® switch,

within 10 seconds. The LED will stop

flashing and the vehicle should start.

If it does not, you may have waited too

long. Turn the ignition off and try again.

Silent Mode

Use the Silent Mode to temporarily turn off the arm or disarm con-

firmation honks by briefly pressing

disarming the system. The confirmation honk(s) will then be elim-

inated for that one operation only. To permanently turn off the arm

and disarm confirmation honks, contact your installation dealer.

Valet Mode

You can prevent your system from automatically activating the

Failsafe® Starter Kill relay and locking the doors, by using Valet®

Mode. This is very useful when washing the vehicle or having it ser-

viced. In Valet® Mode, the system will not activate the Starter Kill,

even with the transmitter, but all convenience functions (door

locks, trunk release, etc.) will work normally.

DRW-35

before either arming or

1999 Directed Electronics, Inc.