Clarke HSE200A 운영 및 유지보수 지침 매뉴얼 - 페이지 8

{카테고리_이름} Clarke HSE200A에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke HSE200A 17 페이지. Submersible pumps
Clarke HSE200A에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (20 페이지)

페이지 인쇄
Clarke HSE200A 운영 및 유지보수 지침 매뉴얼
NOTE: When the pump is being used in a permanent or semi-permanent
installation, a check valve must be fitted in the delivery hose. Suitable
hoses are available from your Clarke dealer.
USING THE PUMP
1. Take all necessary precautions as described on page 4 before plugging in
the pump and switching ON. Where the pump is an automatic unit fitted
with a float switch, the pump will only run where there is sufficient depth of
water for the float to rise and activate the pump.
If the water is likely to freeze, the pump must be run continuously, otherwise
the pump must be removed from the water and stored in a frost free
location.
2. Never run the pump dry. Never run the pump with the body exposed for
more than 10 minutes.
3. When the water has been pumped out, disconnect from the power supply.
Avoid running the pump continuously.

AUTOMATIC THERMAL OVERLOAD

These pumps are fitted with automatic thermal overload protection. If the
pump overheats due to an obstruction in the pump, or pumping warm water
for example, it will shut off automatically. Switch the pump OFF and
disconnect from the mains supply. Check for blockages and allow the motor
to cool (at least 5 minutes) before attempting to restart, by which time the cut-
out will have reset.
ACCESSORIES
A wide range of accessories is available from your nearest CLARKE dealer, for
further information, contact your nearest dealer, or telephone CLARKE
International Sales department on 01992 565300.
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
8