Directed Electronics AS-1775 사용자 설명서 - 페이지 7

{카테고리_이름} Directed Electronics AS-1775에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics AS-1775 14 페이지. Smart start 5 button automatic /manual transmission remote starter
Directed Electronics AS-1775에 대해서도 마찬가지입니다: 사용자 설명서 (13 페이지)

페이지 인쇄

Remote Starter Features

Remote Door Locks

If your system was installed with the Remote Door Locks option, you will have the convenience of

remote keyless entry.

To lock your doors and arm the starter kill (if installed):

Press and hold the

The parking lights will flash once to confirm that the doors have been locked

To unlock your doors and disarm the starter kill (if installed):

Press and hold the

The parking lights will flash twice to confirm that the doors have been unlocked.

Remote Trunk Release

If your system was installed with the Remote Trunk Release option, you can open your trunk by

pressing the

button for 3 seconds on the remote transmitter.

Idle Mode

Convenience feature: Idle Mode allows you to keep the engine running and the doors locked

while you stop, for example, at a convenience store or for a short delivery.

This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the

Ignition Switch) while the engine is running.

Activating Idle mode (Automatic transmission):

With the engine running, make sure to release the brake pedal and press the

button on the transmitter until the parking lights come ON.

Note: SmartStart™ can be setup to use the

or Ready mode.

Remove the ignition key from the ignition switch.

The engine will continue running.

Exit the vehicle. All doors, the hood and trunk should be closed

Press the

engine will be kept running at idle speed.

When re-entering the vehicle, the user must reinsert the key into the ignition and

turn it to the ON position (not Crank) without pressing on the brake.

Once the key is in the ON position, press on the brake pedal to put the

transmission in gear.

Drive off.

If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as

that used for Ready Mode (page-5); at the last step, the

buttons. This will lock the doors, arm the system and leave the engine running.

NEW FEATURE – Push-To-Start Idle Mode

This feature is a variation of "Idle mode", but made specifically for Push-To-Start vehicles, with

automatic or manual transmissions. (Consult your installer for availability of this feature.) Follow the

same steps as the normal Idle Mode procedure, except for when re-entering the vehicle while the

engine is running;

User guide

button for approx. 1 sec.

button to lock the doors, to arm the starter kill and to arm the alarm. The

icon to activate Idle mode, Turbo mode

button is pressed instead of the other

P.7