Directed Electronics Auto Mate AM15 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Directed Electronics Auto Mate AM15에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Auto Mate AM15 6 페이지. Data start system for nissan with lcd 2way remote

Battery replacement
TRX722-2 transceiver
Slide the battery compartment door on back of transceiver.
(FIG.: 1)
Once cover as been removed, insert AAA 1.5v battery
(Make sure polarity is correct + / -)
Replace cover and check for operation.
Note: Normal battery life is approximately two years, but can vary depending on use. Change once a year for best performance.
Remote car starter indication
Remote started
Remote starter normally stop
Engine don't start
Hood open / Brake
Starting with Service mode activated
TRX722-2 Transceiver's functions
Lock:
Press one time on this button to lock all doors. The
parking light will flash once to confirm and this icon will
appear in LCD screen:
Trunk (if applicable and installed)
To open the trunk, press this button for 4
seconds and release. The parking lights will
flash 3 times to confirm and this icon will appear
in LCD screen:
ICON STATUS REFERENCE CHART
Lock/Unlock
Vibration
Confirmation
To operate two cars with the same 2way transceiver
While the
icon display on the LCD screen, you can remote control and communicate with a second vehicle security
2
system. (if both cars have the same system installed and tranceiver programmed by your installer).
1- Press and hold
&
2- Within 5 seconds, press
You can now operate the second vehicle previously programmed in your tranceiver.
* To operate car #1, redo steps 1 & 2, and the
Vibration mode
It is useful when you are in a noisy place and have difficulty hearing the beep sound from the remote control with the
tranceiver in this mode, tranceiver will vibrate if your security system is triggered.
1- Press and hold
&
2- Within 5 seconds, press
When an event happens on your vehicle, the tranceiver will vibrate instead of beeping.
* To return to beeping mode, redo steps 1 & 2, and the
System
Open hood
Open trunk
detected
detected
buttons at the same time until one long beep is heard. Then, release buttons.
2
button once &
icon will appear on the LCD screen of tranceiver, in the middle of the car.
2
icon will disapear.
buttons at the same time until one long beep is heard. Then, release buttons.
button once &
icon will appear on the LCD screen of tranceiver, at the bottom of the car.
FIG.: 1
Lift cover
before
slidding
Parking lights
ON
2 flashes
3 flashes
4 flashes
5 flashes
Unlock:
Press on this button to unlock all doors. The parking
lights will flash twice and the dome light will come
ON. This icon will appear in LCD screen:
Remote start:
Press once on this button and release. The parking
lights will flash to confirm the system received the
signal. Parking light will stay ON while engine is
running and this icon will appear in LCD screen:
To remote stop the engine:
Press on this same button once and release, the
engine will stop. The parking lights will flash twice to
confirm.
Open door(s)
Start
detected
successfully
icon will disapear.
Slide the door in this direction
2
Second car
Valet mode
Operation
G4311A
Timer Control
start
4
2007-12