Clarke HSE301A 운영 및 유지보수 지침 매뉴얼 - 페이지 5

{카테고리_이름} Clarke HSE301A에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke HSE301A 17 페이지. Submersible pumps
Clarke HSE301A에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (20 페이지)

페이지 인쇄

• The YELLOW AND GREEN wire must be connected to the terminal which

is marked E

The HSE301 & 361

suitably approved connector. On no account must a 230V, 13amp plug be

used.

NOTE: If a portable 110V transformer is used, make sure it has a rated

capacity sufficient to take the load of the pump.

In the event that the pump is hard-wired into the electrical system, it must be

carried out in accordance with IEE regulations.

FUSE RATING

The fuse in the plug for this pump must be rated according to the Technical

Specification.

If this product is fitted with a plug which is moulded onto the electrical cable

(i.e. non-rewirable) please note:

1. The plug must be thrown away if it is cut from the cable. There is a danger

of electric shock if it is subsequently inserted into a socket outlet.

2. Never use the plug without the fuse cover fitted.

3. Replacement fuse covers can be obtained from your local dealer or most

electrical outlets.

4. The fuse in the plug must be replaced with one of the same rating and this

replacement must be ASTA approved to BS1362.

IMPORTANT: If in doubt, consult a qualified electrician.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]

or coloured green.

must be connected to a protected 110V supply through a