Clarke HSE360 운영 및 유지보수 지침 매뉴얼 - 페이지 7

{카테고리_이름} Clarke HSE360에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke HSE360 17 페이지. Submersible pumps
Clarke HSE360에 대해서도 마찬가지입니다: 운영 및 유지 관리 지침 (20 페이지)

페이지 인쇄

• It is not recommended that these pumps be used for pumping drinking

water, as there is a remote possibility of water contamination due to

leakage of pump lubricant should the pump malfunction or the oil seal

become damaged.

All HSE pumps are provided with a thermal overload cut-out, so that in the

event the pump becomes overheated (due to becoming blocked etc.) the

pump will shut off automatically. When the blockage has been cleared, the

thermal overload will cool down and re-set and the pump can be re-started.

OPERATION

CONNECTION AND LOCATION

1. Place the pump in a vertical position resting on a firm, flat surface. If this is

not available, sit the pump on timber or house bricks, but ensure they are

not likely to collapse. Never install the pump on sand, silt, mud or ground

that is likely to collapse.

Automatic versions should only be placed in a sump which is large enough

not to restrict the movement of the float switch. It is advisable to use a

strainer when using the pump as a sump pump.

2. Keep the pump clear of any

sediment by standing it on a

platform or brick or suspending

from a rope attached to the

handle if the pump is to be

used where there may be silt or

mud etc (e.g. garden ponds).

3. Connect the outlet to the

largest diameter hose

available, as any restrictions will

reduce capacity and put

further strain on the motor. The

outlet hose diameter for each

HSE pump is given in the

Technical Specification.

4. Ensure that the hose diameter is

equal to or greater than the diameter of the pump outlet if a long run of

discharge hose is being used.

5. Ensure the float has sufficient room to operate correctly if used in a

confined space such as a shaft or sump.

Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]