Clarke ISP11A 운영 및 유지보수 지침 매뉴얼 - 페이지 3

{카테고리_이름} Clarke ISP11A에 대한 운영 및 유지보수 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke ISP11A 12 페이지. Submersible water pump

SAFETY PRECAUTIONS

This pump is designed to pump WATER ONLY. Never use for pumping

flammable liquids or chemicals of any kind.

NEVER allow the pump to run dry.

An approved Residual Current Device (RCD) MUST be used when pumping

from ponds or swimming pools.

Your submersible pump may ONLY be used for pumping water from a swimming

pool when there is no person or animal in the pool.

ALWAYS disconnect the pump from the electrical supply

before placing into, or removing from water, and

before any cleaning or maintenance.

When raising or lowering the pump, ALWAYS use

a rope or chain attached tothe handle. NEVER

lift or carry the pump by the mains cable or the

float switch cable.

DO NOT run the pump with the body exposed

for longer than 10 minutes.

DO NOT install the pump on sand, silt, mud etc.,

or ground which is likely to shift.

If pumping water which is liable to freeze, the

pump MUST be run continuously, otherwise the pump must

be removed from the water and stored in a frost free location.

10. If the pump is to be used where there may be silt or mud

(e.g., garden ponds), ALWAYS keep the pump clear of any sediment by

standing it on a platform or bricks or suspending from a rope or chain attached

to the handle.

11. DO NOT use for permanent installation in pumping clean or pure water,

(particularly drinking water), as there is the remote risk of contamination, should

there be a leak in the seal device.

12. If the mains cable becomes damaged, it MUST be replaced - NOT repaired.

(see Electrical Installation).

13. If used in a confined space - in a shaft or sump etc., ENSURE the float has

sufficient room to operate correctly (see Installation on page 6).

14. Connection to the mains supply MUST be made well clear of the water, or, if in close

proximity, it must be completely waterproofed and secured to prevent the possibility

of it coming into contact with water. If necessary consult a qualified technician.

Failure to comply with these safety precautions could be extremely

hazardous, not only causing a risk to personal safety but also damage to

the pump, which could invalidate your guarantee.

WARNING