Alemite 7343 서비스 매뉴얼 - 페이지 8

{카테고리_이름} Alemite 7343에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 7343 8 페이지. High capacity twin hose reel

페이지 인쇄

SER 7343

Indications

Reel does not latch

Pawl Spring (29) broken or not attached to Pawl and

Shaft Assembly (28)

Reel does not retract

Power spring broken*

Reel retracts partially

1. Improper power spring tension

2. Hose length greater than recommendation

Reel does not unlatch

1. Power spring wound solid

after maximum length

2. Hose removed from the reel too quickly

of hose is removed

(Reel Over-Run)

Material leakage at

1. Connection not sufficiently tight and / or thread

Swivel Assembly (2)

sealant missing at Bushing (1)

2. Worn or damaged O-Rings (2c)

3. Worn or damaged O-Ring (2f)

4. Worn or damaged Swivel Stem (2e)

Material leakage from

1. Delivery hose connection not sufficiently tight

delivery hose

2. Thread sealant missing at Unions (22) or Bushings

connections

(1) and / or Unions and / or Bushings not

sufficiently tight into Shaft (19) or Shaft and

Flange Assembly (20)

* The possible causes for broken components are listed in italics

Revision (11-08)

1-800-548-1191-http://[email protected]

Troubleshooting Chart

Possible Problems

Changes Since Last Printing

339389-3 for 8080-K

339389-4 for 8080-L

High Capacity Twin Hose Reel

Solution

Replace or secure Pawl Spring (29)

Replace Power Spring Assembly (26)

1. Adjust tension

2. See Table 1.

1. Decrease power spring pre-wind

2. Remove hose slowly when close to being fully

extended

1. Apply sealant to male threads of

Bushing (1) and tighten connections

2. Replace O-Rings (2c)

3. Replace O-Ring (2f) or use Repair Kit 393781

4. Replace Swivel Stem (2e)

1. Tighten connection

2. Apply thread sealant to Unions (22) or Bushings

(1) and tighten into Shaft (19) or Shaft and

Flange Assembly (20)

Alemite, LLC