Directed Electronics Clifford G4203X 소유자 매뉴얼 - 페이지 11
{카테고리_이름} Directed Electronics Clifford G4203X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Clifford G4203X 20 페이지. Clifford responder one remote start owner's guide
페이지 인쇄
To shut off the remote start:
While the vehicle is remote started press and hold the button on the
remote for 3 seconds. The remote plays the remote start shut off tones
and the orange LED flashes 1 time. The vehicle shuts down from the
remote start mode.
Once the remote start is on, when you are ready to drive the vehicle:
1.
Insert the ignition key and turn it to the ON
(not the START) position.
2.
Press the brake pedal. The vehicle stays running and is ready to
drive.
Note:
If the brake pedal is pressed before the key is in the ON position,
the engine shuts down.
While the vehicle is running during remote start operation, the system
monitors the vehicle and automatically shuts down the engine if the
system receives any of the following shut-down inputs:
•
The brake pedal is pressed.
•
The hood is opened.
•
The shutdown toggle switch is put into the ON position.
•
The pre-programmed run time has elapsed.
•
The single button is pressed and held for 3 seconds.
© 2008 Directed Electronics. All rights reserved.
11