Directed Electronics Clifford G4203X 소유자 매뉴얼 - 페이지 8
{카테고리_이름} Directed Electronics Clifford G4203X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Clifford G4203X 20 페이지. Clifford responder one remote start owner's guide
페이지 인쇄
➢ Battery Replacement
Note:
Verify that the battery polarity is correct when replacing.
Batteries are stacked in series and polarity is indicated.
3.
Reposition all parts and snap together
8
Elastomer
1.
Using a small slotted screw-
contact
driver, insert into slot located on
the side of the unit as shown and
carefully pry the front of the unit
up, working your way around the
edge until the front is completely
separated
from
Front
Note:
Make sure that the small elas-
tomer contact located inside the unit
as shown does not fall out during the
replacement process.
2.
Turn the circuit board over,
remove batteries from clip and re-
Elastomer
contact
place.
the
housing.
© 2008 Directed Electronics. All rights reserved.
Front
Front
Elastomer
contact
Elastomer
contact
Circuit Board
+ +
+
Front
Elastomer
contact