Directed Electronics CT-3271 사용자 설명서 - 페이지 7
{카테고리_이름} Directed Electronics CT-3271에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics CT-3271 13 페이지. Automatic transmission multi-channel remote starter system
페이지 인쇄Remote Starter Features
Remote Door Locks
Note: This feature is only available if button
If your system was installed with the Remote Door Locks option, you will have the convenience of
remote keyless entry.
To LOCK your doors and ARM the system (if installed):
1.
Press and hold the
2.
The parking lights will flash once to confirm locking of the doors and arming of the Starter Kill.
To UNLOCK your doors and DISARM the system (if installed):
1.
Press and hold the
2.
The parking lights will flash twice and the LED will go out to confirm unlocking of the doors
and that the Starter Kill feature is disarmed.
Remote Trunk Release
If your system was installed with the Remote Trunk Release option, you can open your trunk by
pressing the
&
Idle Mode
Convenience feature: Idle Mode allows you to keep the engine running and the doors locked
while you stop, for example, at a convenience store or for a short delivery.
This feature allows you to let the remote starter take over control of the vehicle (i.e. no Key in the
Ignition Switch) while the engine is running.
Activating Idle mode (Automatic transmission):
1.
With the engine running, make sure to release the brake pedal and press the
the transmitter until the parking lights come ON.
Note: SmartStart™ can be setup to use the SmartStart™ icon to activate Idle mode.
2.
Remove the ignition key from the ignition switch.
The engine will continue running.
3.
Exit the vehicle. All doors, the hood and trunk should be closed
4.
Press the
button to lock the doors and to arm the starter kill (if available). The engine will
continue running.
a.
When re-entering the vehicle, the user must reinsert the key into the ignition and turn it
to the ON position (not Crank) without pressing on the brake.
b.
Once the key is in the ON position, press on the brake pedal to put the transmission in
gear. Pressing the brake pedal at this step will cancel the remote starter takeover.
c.
Drive off.
If your vehicle has a manual transmission, Idle Mode can be activated through the same routine as
that used for Ready Mode (page 4); at the last step, press the
the doors and leave the engine running.
User guide
button for approx. 1 sec.
button for approx. 1 sec.
simultaneously for 3 seconds on the remote transmitter.
is programmed as LOCK or UNLOCK.
&
button on
buttons together to lock
P.7