Clarke Strong Arm CS10PRH 운영 및 유지 관리 지침 - 페이지 5

{카테고리_이름} Clarke Strong Arm CS10PRH에 대한 운영 및 유지 관리 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke Strong Arm CS10PRH 13 페이지. 10 tonne hydraulic pump, ram & hose

페이지 인쇄

OPERATION

Assemble the components including a flat base and as many extension tubes

as required.

NOTE THAT WHEN ADDING FURTHER EXTENSION TUBES, THE MAXIMUM

RATED LOAD IS REDUCED. (SEE WARNING LABEL)

1. Connect the Hydraulic Ram or Hydraulic Spreader to the connecting hose

using the screw-on hose connector. Use the male connector to join the

ram to your selected attachment or any extension tube.

2. To operate the Hydraulic Pump, position it on a stable, level surface close

to the damaged area. Close the Release Valve by turning it clockwise

and pump the handle to create pressure.

3. Turn the Release Valve counter-clockwise to release the pressure.

• The pump may be positioned horizontally or vertically. When using the

Hydraulic Ram in a vertical position, always keep the hose end facing

downward.

NEVER OVERLOAD THE RAM BEYOND ITS CAPACITY. ENSURE THE

BEARING POINT IS STABLE AND PROPERLY CENTRED ABOVE THE RAM.

NEVER OVERLOAD THE ATTACHED COMPONENTS BEYOND THEIR RATED

CAPACITIES AS STATED IN THE SPECIFICATION.

Always apply the load slowly to be sure that everything is secure. Take care

that the load is always in line with the ram.

USING THE RAM

1. Determine in which direction the target area needs to be pushed.

2. Remove any obstructions that are in the way and could be damaged.

3. Connect a Flat Base to the stationary side of the Hydraulic Ram and

connect the appropriate attachment to the working end of the Ram.

Note: When repairing larger body panel dents such as a dented door,

wing or quarter panel, the correct pushing attachment will be the Rubber

Head.

4. Position the Hydraulic Ram so that the flat base is resting against a frame

member opposite the damaged area. It must be in line with the direction

in which the damaged area needs to be pushed and have enough

support that only the damaged area will be displaced by the ram

pressure.

• Use soft pads or wooden supports where necessary to protect the body.

Parts & Service: 020 8988 7400/E-mail:[email protected] or [email protected]