Alemite 3622 서비스 매뉴얼 - 페이지 9

{카테고리_이름} Alemite 3622에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 3622 11 페이지. Electronic-metered control valve

Electronic-Metered Control Valve

Electronic Meter Assembly

Refer to Service Guide SER 3630 for complete details.

Metered Control Valve

IMPORTANT: Apply thread sealant to all

pipe thread connections prior to assembly.

1. Screw Nipple (3) into Meter Assembly (2).

• Do not tighten at this time.

2. Screw Control Valve Handle Assembly (4) onto the

Nipple.

• Tighten the Nipple into the Handle and the Meter at

the same time.

• Make sure to align the Handle properly with the

Meter.

3. Connect the components of the extension assembly

and tighten securely.

4. Screw the extension assembly into Meter Assembly

(2).

• Tighten the extension securely.

Alemite LLC

1-800-548-1191-http://[email protected]

Figure 6

Control Valve Handle 339100 - Section View

Attach the Swivel Assembly [with thread sealant] to its

delivery line. Tighten the connection securely.

Operation

WARNING

Should leakage occur anywhere within the

system, disconnect power to the motor. Personal

injury can occur.

1. Squeeze the Lever to ensure the safety engages

properly.

2. Press the button in the center of the Lever and operate

the Lever. The Lever should move to the open

position.

3. Release the Lever (while pressing the button) then

release the button to ensure the latch engages properly.

4. Press the Lever and release to release the latch.

If the safety and/or latch does not operate properly,

refer to the Control Valve Troubleshooting Chart.

SER 3620

Refer to Figure 5 Parts List

for Parts Identification

Revision (11-05)