Alemite 3640 서비스 매뉴얼 - 페이지 11

{카테고리_이름} Alemite 3640에 대한 서비스 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Alemite 3640 14 페이지. Electronic preset metered control valve

페이지 인쇄

1. Meter Programming

Electronic Preset Metered Control Valve

Control Valve Assembly

Battery Door

1. Remove Screws (43) that secure Battery Door (42) to

Bottom Case (41).

• Separate the Battery Door (with batteries) from the

Bottom Case.

Valve Case

2. Remove Screws (43) that secure Case Cover (44) and

Partition (45) to the Bottom Case.

• Remove the Case Cover and the Partition from the

Bottom Case.

3. Remove four Screws (46) that secure Bottom Case (41 )

to Housing (37).

4. Push the Battery terminals from the Bottom Case.

• Separate the Bottom Case from the Housing.

5. Remove four Screws (18) that secure the Housing to Top

Case (16).

6. Remove one additional Screw (17) that secures the Top

Case to the Housing.

• Separate the Top Case from the Housing.

7. Remove Keypad (19) from the Top Case.

Solenoid

8. Carefully pull the terminal connector from

Solenoid (48).

9. Unscrew the Solenoid from the Housing.

10. Remove Detent Ball (47).

Circuit Board and Metering Gears

11. Remove three Screws (22) that secure Circuit Board

(21) to Housing Cover (33).

• Remove the Circuit Board from the Housing.

NOTE: The lower right-hand screw contains

external tooth washer (23).

12. Remove Screws (32) that secure the Housing Cover to

the Housing.

• Remove the Housing Cover from the Housing.

13. Remove Gears (35 and 36) and O-Ring (34) from the

Housing.

Alemite Corporation

Valve Mechanism

14. Remove Stop Pin (20) from Nut (24).

15. Unscrew the Nut from the Housing.

• Remove O-Ring (26) and Seal (25) from the Nut.

16. Remove Spring (27), Valve (30) [with

O-Ring (28), Back-Up Ring (29), and Seal (31)] from

the Housing.

Lever Mechanism

IMPORTANT: Use care not to lose Spring

(40) during the removal of Lever (39).

17. Remove Roll Pin (38) that secures Lever (39) to the

Housing as required.

• Remove the Lever and Spring (40) from the Housing.

Swivel

18. Unscrew Swivel (13) from the Valve's Housing.

19. Remove O-Ring (12), O-Ring (15), and Screen (14)

from the Swivel.

Clean and Inspect

1. Clean all metal parts in cleaning solvent. The solvent

should be environmentally safe.

2. Inspect all parts for wear and/or damage.

• Replace as necessary.

3. Closely inspect the mating surfaces of all components

for any imperfections. Ensure a smooth and clean

contact is obtained when assembled.

4. Closely inspect the mating surfaces of Cover (33) and

Housing (37) for any imperfections. Ensure a smooth

and clean contact is obtained when assembled.

SER 3640

Revision (10-04)