Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 사용자 설명서 - 페이지 11

{카테고리_이름} Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 18 페이지. Two-way fm led automatic/manual transmission remote starter

페이지 인쇄

Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 사용자 설명서

To enter Cold Weather Mode (1-way remote):

Rapidly press AUX twice. The remote's LED will start flashing.

Press and hold

3 times.

To exit Cold Weather Mode, do any one of the following actions:

•

Open the hood.

•

Start the engine remotely.

•

Turn the ignition key to the IGNITION ON (RUN) position.

•

Press and release the AUX button.

•

(1-way remote) Rapidly press AUX twice. The re mote's LED will start flashing. Press

and hold

To verify whether the system is in Cold Weather Mode:

• (Automatic transmissions only) Press the brake pedal: If the vehicle is in Cold Weather

mode, the parking lights will remain ON while the brake pedal is pressed.

• Do the vehicle status request feature (page-16).

Extended Run Time

While the vehicle is running under a remote start, press and hold the

beeps. This will reset the run time counter to zero and restart the run time cycle from the beginning.

Note: The extended run time procedure can only be carried out once per remote start.

To stop the vehicle, at any moment, simply press and release the

Example: If your remote car starter is programmed for a run time of 3 minutes and your vehicle

has been running for 2 minutes already, pressing the

allow the engine to run for another cycle (in this case, 3 minutes).

Disable/Enable LED flashing

To disable the LED: Press

2 seconds, then beeps once again. Release the buttons. The parking lights will flash 3 times.

To Enable the LED: Press

2 seconds, then beeps once more. Release the buttons. The parking lights flash once.

Constant output

Pressing and holding the

constant pulse as long as the

pulse can be configured to activate certain functionalities such as rolling up the windows – Please

refer to your installer to see if your vehicle is compatible with this option.

Pressing and holding the

constant pulse as long as the

pulse can be configured to activate certain functionalities such as rolling down the windows –

Please refer to your installer to see if your vehicle is compatible with this option.

User Guide

until the parking lights will flash for 2 seconds, pause, and then flash

The

button on the transmitter will light up.

While the

button is still lit, press and hold the

beeps once, pause, then beeps once again.

Release the

button. Its LED will flash quickly.

until the parking lights flash for 2 seconds, pause, and then flash twice.

and

simultaneously until the remote beeps once, pauses for

and

simultaneously until the remote beeps once, pauses for

button for more than 3 seconds will lock all doors and will send a

button is held down (maximum of 15 seconds). This constant

button for more than 3 seconds will unlock all doors and will send a

button is held down (maximum of 15 seconds). This constant

button until the remote

button.

button will reset the counter to zero and

P.11