Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 사용자 설명서 - 페이지 14

{카테고리_이름} Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 18 페이지. Two-way fm led automatic/manual transmission remote starter

Directed Electronics TWO-WAY FM LED AUTOMATIC/MANUALTRANSMISSION REMOTE STARTER 사용자 설명서
"Home Valet
TM
If configured at installation, this feature will remotely set the vehicle to a no-remote-start mode: if
the vehicle is parked indoors there is no danger of it starting accidentally by remote control. If the
vehicle has a manual transmission, it should be set into ready mode before activating the Home
Valet™.
Note: Once the Home Valet Mode is activated, the vehicle will not start by remote, but the OEM
alarm functions will remain active.
To take the system into home valet mode:
1.
Press the
2.
Within 3 seconds, press the
beeps twice.
To take the system out of home valet mode:
Turn the ignition key to the IGNITION ON (RUN) position.
The system will warn you if someone attempts to start your vehicle while it stands
in home valet mode. The parking lights will:
AUX 1 
Note: This 500 mA negative Aux 1 output can be used for many different applications
Priority door:
This great feature allows the user to unlock solely the driver's door with a single press of the
button on the transmitter, and to unlock the other doors, if desired, by pressing the
second time.
The output will provide a 1-second negative output when the
on the transmitter.
Horn Confirmation:
AUX 1 can be programmed to trigger the horn every time the
button is pressed twice within 3 seconds. When horn confirmation is activated, panic mode is
enabled. If horn confirmation is disabled, panic mode will not be available.
AUX 2 
If configured at installation, this feature can be activated by pressing the AUX (or Shift) button,
followed by pressing and holding the lit up
Horn Timing Adjustment 
The pulse duration can be configured by your installer (from 5 ms to 200 ms).
P.14
" Mode 
or
button.
• Turn ON then OFF; then
Flash twice, pause; then
Flash twice again.
and
buttons simultaneously until the remote
button to activate AUX 2.
 
button is pressed a second time
button is pressed, or when the
User Guide
button for a