Clarke 01193B 운영자 매뉴얼 - 페이지 7

{카테고리_이름} Clarke 01193B에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke 01193B 20 페이지. Ultra speed burnisher

페이지 인쇄

HOW TO OPERATE THE MACHINE

WARNING: Machines can ignite flam-

mable materials and vapors.

Do not use with or near flam-

mables, such as:

grain dust, solvents and

thinners.

CAUTION:

Allowing the machine to run

without moving forward or

backward can cause serious

damage to the floor surface.

Make sure the machine is al-

ways moving when the pad is

rotating.

NOTE: You must have training in the operation of

this machine before you use it.

How To Start/Stop The Machine

The normal position of this burnisher, with the pad station-

ary, is tilted back with the pad off the floor.

1. Remove cable completely from cable hook.

2. With the handle in operating position and the power

cable plugged into the proper outlet, depress the

interlock button (1) and squeeze the levers beneath

the handle grips (2).

As the motor reaches full speed (1-2 seconds), bring

the pad into contact with the floor.

NOTE: Make sure you hold the handle with both

hands.

How To Operate the Machine

For best results, use a clean pad and change frequently

as pad loads up. A motor overload could result from a

dirty, loaded pad. If the built-in circuit breaker trips, turn

off the machine, wait five (5) seconds, then depress the

reset button on the circuit breaker. Change the pad.

The Circuit Breaker

A circuit breaker is used to protect the motor. If the motor

draws high current, the circuit breaker will stop the motor.

The circuit breaker reset button is on the rear of the motor

cover. Push the reset button to reset the circuit breaker.

If the motor continues to stop, consult an authorized

service person.

CLARKE TECHNOLOGY Operator's Manual - Ultra Speed Burnisher 1700

gasoline,

(See figure 3).

Figure 3

Page -7 -