Directed Electronics Honda/Acura SIRIUS Interface HON-SC1 설치 매뉴얼 - 페이지 15
{카테고리_이름} Directed Electronics Honda/Acura SIRIUS Interface HON-SC1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Honda/Acura SIRIUS Interface HON-SC1 20 페이지. Sirius interface honda/acura
Directed Electronics Honda/Acura SIRIUS Interface HON-SC1에 대해서도 마찬가지입니다: 설치 매뉴얼 (20 페이지)
페이지 인쇄
Operating the system
SAT radio selection
Press the SAT button to access the Sirius interface. On
some radios this button may be labeled as XM or CD/SAT.
Pressing this button repeatedly will cycle through sources.
Operation
Use the category control buttons to change a category, if
desired.
Use the channel control buttons to change channels.
Consecutive presses engage the channel browse mode
allowing preview of a channel without tuning. Once the tune
button is disengaged channel selection takes place.
Press and hold one of the preset buttons until a beep is
heard to save a preset.
To listen to a preset station simply press the desired preset
button.
When CATEGORY tune mode is selected the button will
cycle through channels only within the current category.
The SCAN button previews a station for a few seconds be-
fore changing channel to another. Once the desired station
is reached press the SCAN again.
Advisory message
"No tuner" - displayed when connection to Sirius tuner or
Sirius dock is bad, no tuner is connected or if vehicle
ACC power is not cycled once after connecting the
© Directed Electronics, all rights reserved.
Honda/Acura SIRIUS Interface
Desktop Docking Station
interface.
"Connecting" - displayed during the initialization of the
Sirius tuner.
"Antenna Error" - displayed when the antenna connection
is not detected.
"Acquiring Signal" - displayed while acquiring digital audio
stream or when the received signal drops below mini-
mum required for tuner to operate.
"Unsubsc. Channel" - displayed when the selected channel
is no longer subscribed
"Subscrip. Updated" - displayed when a subscription
update received
"Invalid Channel" - indicates that a program became un-
available after an update
"Updating XX/100" - indicates Sirius channel map update
in progress
"Firmware Update" - indicates an over the air firmware
update of the tuner
"Radio id" - on CH000 - shows the Sirius ESN needed for
subscription services
The 12 digit Sirius ID is shown alternating: the first 6 digit
is followed by a "-", the last 6 digit is preceded by a "-"
Portable receivers
You may connect or disconnect portable receivers at any
time. Upon connection the "docked portable " message
will replace the "No tuner" followed by "Acquiring Signal"
before content becomes available.
15