Directed Electronics 64601910 d2500.1 소유자 매뉴얼 - 페이지 12

{카테고리_이름} Directed Electronics 64601910 d2500.1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics 64601910 d2500.1 20 페이지. Directed electronics, inc power amplifier owner's manual

페이지 인쇄

TOP PANEL FEATURES

Control Panel Cover

The amplifier's gain and filter controls

are mounted under the elliptical control

panel cover. Magnets hold the cover

snugly and allow easy access.

T T o o i i n n s s t t a a l l l l t t h h e e c c o o v v e e r r - Place the

straight end of the control panel

cover into the notched end of the

amplifier's

top

elevating the curved end. Lower the

curved end of the cover until the

magnets make contact.

T T o o r r e e m m o o v v e e t t h h e e c c o o v v e e r r - Place a finger

on the curved end of the cover

while lifting up the straight end

with your thumb. When the

magnets lose contact, lift and

remove the cover.

Illuminated Window

Alignment

The illuminated window comes attached

to the control panel cover with a light

adhesive tape. An additional supply of

precut adhesive tape is included in the

hardware pack.

1. Firmly hold the control panel cover

while gently pressing against the

window from the top. If the

window will not release easily use a

small flat tool to pry it loose. Pry

slowly and evenly from several

points to avoid deforming or

cracking the window.

2. Apply two of the precut pieces of

3. Turn the illuminated window so the

panel

while

Viper Badge Mounting

The Viper Badge can be rotated in 90-

degree increments to accommodate the

amplifier's final mounting position.

1. Determine the final mounting posi-

2. Determine the position required for

3. Remove the protective cover for the

4. Align the badge guideposts with the

5. Press down firmly until the logo is

adhesive tape to the corners of the

window that don't have tape. Make

sure to apply the tape to the side

that makes contact with the cover.

Save the other two precut pieces of

tape for future use.

Viper snake logo will be in an

upright position when the cover is

re-attached to the amplifier. Press

the window onto the underside of

the control panel cover using the

positioning pins for alignment.

tion of the amplifier.

the badge to be viewed horizontally.

adhesive tape on the under side of

the badge.

holes in the amplifier top panel.

securely attached to the amplifier.