Directed Electronics Viper Audio d2500.1 소유자 매뉴얼 - 페이지 16

{카테고리_이름} Directed Electronics Viper Audio d2500.1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Viper Audio d2500.1 20 페이지. Directed electronics, inc power amplifier owner's manual

페이지 인쇄

PARALLEL SYNCED GAIN CONNECTIONS/SETTINGS

1. I I n n p p u u t t S S i i g g n n a a l l - Connect these RCA

jacks as described in the Front Panel

Connection section of this guide.

2. S S l l a a v v e e / / M M a a s s t t e e r r S S w w i i t t c c h h

Set the slave/master switch

on the master amplifier to the

MASTER position.

Set the slave/master switch

on the slave amplifier to the SLAVE

position.

Setting the slave/master

switch on both amplifiers will auto-

matically set the I/O RCA jack

configuration according to each

amplifier's slave or master designa-

tion.

N N O O T T E E : :

One master amplifier can control up to three slave

amplifiers in this combination. Multiple identical

master/slave combinations can be added to any

given system.

3. R R e e m m o o t t e e S S u u b b L L e e v v e e l l C C o o n n t t r r o o l l - Connect

the Remote Sub Level Control to the

master amplifier only. The master

amplifiers subwoofer gain is used to

set the overall gain for all synced

amplifiers, then the Remote Sub

Level Control can adjust the gain of

all synced amplifiers.

4. S S i i g g n n a a l l C C o o n n n n e e c c t t i i o o n n - Connect an RCA

cable between the SYNC OUT RCA

jack of the master amplifier and the

SLAVE IN RCA jack of the slave

amplifier as shown in Figure 5.

5. S S u u b b w w o o o o f f e e r r S S p p e e a a k k e e r r C C o o n n n n e e c c t t i i o o n n - In

this amplifier combination each

amplifiers must drive its own sepa-

rate subwoofer(s). Connect the

speaker terminals of each amplifier

to any combination of one or more

subwoofers that results in nominal

impedance between two and four

ohms. Make sure that each amplifier

sees the same speaker impedance.