Directed Electronics SIR-PVK1 설치 매뉴얼 - 페이지 12

{카테고리_이름} Directed Electronics SIR-PVK1에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics SIR-PVK1 16 페이지. Sirius satellite radio professional vehicle install kit

페이지 인쇄

CONNECTING THE SIRIUS RADIO TO THE VEHICLE'S SOUND SYSTEM.

Your Sirius radio can be connected to the vehicle's sound

system different ways depending on whether it is a factory

sound system or aftermarket head unit.

Most factory head units do not have auxiliary inputs. For

the best audio performance, use the supplied FM Direct

Audio Relay to route audio from your Sirius radio. You can

also use the wireless FM modulator built into your Sirius

radio by following the instructions for the wireless modula-

tor contained in the owner's guide.

In some cases the wireless signal will not be strong enough

to overcome interference from local FM stations. In this

case it is recommended to use the supplied FM Direct

Audio Relay included in the kit. This will require pulling the

radio out of the dash and unplugging the vehicle antenna.

The antenna cable will then be plugged into the receptacle

on the FM Direct Audio Relay labeled "to car FM antenna".

The plug labeled "to car FM radio" will then be plugged

into the antenna receptacle on the back of the radio. Some

vehicles may require antenna adapters for this connection,

consult your authorized dealer for details. Then route the

plug labeled "to satellite radio" to the back of the Sirius

cradle and plug it into the FM Out receptacle on the back

of the cradle. Securely bundle and hide any excess cable

behind a panel or under the dash of the vehicle securing it

so that it will stay in place while the vehicle is being driven.

Do not cut or shorten any of the cables of the FM Direct

Audio Relay as it may cause poor performance of the part.

In vehicles with aftermarket head units that have auxiliary

inputs, you can use the supplied 3.5mm stereo to RCA male

adapter cable. Connect the RCA jacks to the auxiliary in-

puts on the head unit and plug the 3.5 mm stereo plug into

the Line Out port on the back of the Sirius cradle. Some

radios may require a specific adapter to support routing

audio into the auxiliary inputs. Consult the owner's or

installation guide for your head unit for information about

using the auxiliary inputs. If the aftermarket head unit

does not have an auxiliary input you will have to use the FM

Direct Audio Relay connections described above for factory

sound systems.

Audio Cable

FM Direct Audio Relay

Dual Voltage

Power Adapter

Dual Volta

3 pin 12v