Directed Electronics Valet 9405T 사용자 설명서 - 페이지 6

{카테고리_이름} Directed Electronics Valet 9405T에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Valet 9405T 9 페이지. Back up sensor

I I n n s s t t a a l l l l a a t t i i o o n n

N N o o t t e e : : Before installing system let the

components of the exhaust system cool

down. This will make the installation safer

and preclude heat damage to the back up

sensor wiring or components.

S S e e n n s s o o r r I I n n s s t t a a l l l l a a t t i i o o n n

1. Verify that the size of the supplied hole saw

is compatible to the diameter of the sensor

before drilling your bumper. Use a scrap piece

of wood for this test.

N N o o t t e e : : Before drilling any holes in the vehicle ensure

that the the area behind is clear of any electrical,

hydraulic, or support members, etc.

2. Install the sensor vertically, the "up" arrow

must be pointing up.

3. Each sensor is numbered, ensure that they are

installed as shown on the illustration.0

Display

Connect to

ignition wire (+)

I I n n s s t t a a l l l l a a t t i i o o n n D D i i a a g g r r a a m m

The following illustration shows the general loca-

tion of the components of the back up system.

0.3L

5 ~ 8 inches

6 6

Sensors

Connect to

reversing light(+)

0.4L

0.3L

5 ~ 8 inches

N9405T 11-05

ECM