Directed Electronics D600 소유자 매뉴얼 - 페이지 6

{카테고리_이름} Directed Electronics D600에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics D600 20 페이지. Dei orion d600: user guide

tem battery.

WARNING:

Always protect this power wire by installing a fuse or circuit breaker of the

appropriate size within 12 inches of the battery terminal connection.

REM - this terminal turns on the amplifier when (+) 12 volt is applied. Connect it

to the remote turn on lead of the head unit or signal source. If a (+) 12 volt remote

turn lead is not available, a Remote Power Adapter (P/N #55000) can be used to

supply a remote turn on signal. DO NOT connect this terminal to constant (+) 12

volt.

GND - power return connection. Connect this terminal directly to the sheet metal

chassis of the vehicle, using the shortest wire necessary to make this connection.

Always use wire of the same gauge or larger than the (+) 12 volt power wire. The

chassis connection point should be scraped free of paint and dirt. Use only quali-

ty crimped and/or soldered connectors at both ends of this wire. DO NOT connect

this terminal directly to the vehicle battery ground terminal or any other factory

ground points.

Speaker - connect the speakers to these terminals. (refer to the Speaker

Connection section of this guide.)

NOTE:

Make all connections to power, ground, speakers, and remote terminals before

final positioning and installation of the amplifier in the vehicle.

CEA SPECIFICATIONS

HCCA-D600

Power Output: 150 Watts RMS x 1 at 4 ohms and < 1% THD+N

Signal to Noise Ratio: -60 dBA (reference 1 Watt into 4 ohms)

Additional Power Output: 300 Watts RMS x 1 at 1 ohm at 14.4 Supply <1% THD+N