Directed Electronics Viper Audio d300.1 소유자 매뉴얼 - 페이지 7

{카테고리_이름} Directed Electronics Viper Audio d300.1에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics Viper Audio d300.1 16 페이지. Directed electronics audio d300.1 owners manual

페이지 인쇄

lower your speaker load, the more

heat is generated. For low imped-

ance speaker applications or

restricted ventilation installations,

an external cooling fan may be

advisable.

9. Battery and ground connections to

the vehicle should be made with

crimped ring terminals of the appro-

priate size (surface area is what

counts); soldering the terminals

after crimping is also recom-

mended.

WIRE CONNECTOR PLUGS

Power and speaker wire connections on

Viper Audio power amplifiers are

performed with the use of specially

designed connectors that allow for ease

of wire termination and installation

convenience.

Poor connections are a common cause

of poor sound quality, or amplifier

performance. Making proper wire

connections is paramount to a reliable,

quality sound system.

Please follow these recommendations to

ensure a problem free installation:

1. Always use the proper gauge wire

for the connector.

2. Cut wires to the minimum length

necessary.

10. Due to the high-frequency MOSFET

switching power supply, filtering the

power cable is not generally

required (remember that the amp

can't deliver full output if the power

supply is restricted). Proper

grounding of the signal source is

mandatory for the amplifier to

reach its performance peak. If the

RCA inputs are not grounded

adequately via the signal source,

electrical noise from the vehicle

may be picked up in the system.

3. Trim the wire ends so bare wire

does not protrude from the

connector after termination.

4. Always tighten the connector

screws firmly at least twice, once

during installation and once more

before returning the car to the

customer.

C C A A U U T T I I O O N N : : Over tightening the screws can cause them to

strip, creating loose connections. Tighten the

screws twice firmly for a permanent, solid

connection.