Directed Electronics xtreme 1500X 소유자 매뉴얼 - 페이지 10

{카테고리_이름} Directed Electronics xtreme 1500X에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Electronics xtreme 1500X 16 페이지. Dei 1500x: user guide

페이지 인쇄

Directed Electronics xtreme 1500X 소유자 매뉴얼

REAR PANEL CONNECTIONS

1. S S p p e e a a k k e e r r O O u u t t T T e e r r m m i i n n a a l l s s - Connect

the speakers to these terminals.

(Refer to the Speaker Connection

section of this guide.)

2. P P o o w w e e r r F F u u s s e e - - This fuse protects the

amplifier against internal electrical

damage and is meant to protect the

amplifier only. All other power

connections should be fused at the

source.

3. ( ( + + ) ) 1 1 2 2 V V o o l l t t P P o o w w e e r r - Connect this

terminal through a FUSE or CIRCUIT

BREAKER to the positive terminal of

the vehicle battery or the positive

terminal of an isolated audio

system battery.

W W A A R R N N I I N N G G : : Always protect this power wire by installing a fuse

or circuit breaker of the appropriate size within

12 inches of the battery terminal connection.

4. R R e e m m o o t t e e T T u u r r n n O O n n - This terminal

turns on the amplifier when (+) 12

volt is applied to it. Connect it to

1 1 0 0

the remote turn on lead of the head

unit or signal source. If a (+) 12

volt remote turn lead is not avail-

able, a Remote Power Adapter

(P/N #55000) can be used to

supply a remote turn on signal. DO

NOT connect this terminal to

constant (+) 12 volt.

5. G G r r o o u u n n d d - - Connect this terminal

directly to the sheet metal chassis

of the vehicle using the shortest

wire necessary to make this

connection. Always use wire of the

same gauge or larger than the (+)

12 volt power wire. The chassis

connection point should be scraped

free of paint and dirt. Use only

quality crimped and/or soldered

connectors at both ends of this

wire. DO NOT connect this terminal

directly to the vehicle battery

ground terminal or any other

factory ground points.