CTEK CHARGESTORM CONNECTED 2 사용자 설명서 - 페이지 5
{카테고리_이름} CTEK CHARGESTORM CONNECTED 2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CTEK CHARGESTORM CONNECTED 2 19 페이지.
CTEK CHARGESTORM CONNECTED 2에 대해서도 마찬가지입니다: 사용자 설명서 (20 페이지)
페이지 인쇄
Installation
Introduction
This part of the instructions shows how to install the
charging station CHARGESTORM® CONNECTED.
Safety
•
Only an accredited electrician is allowed to
perform the installation described in this
document.
•
Read and obey the instructions in this
document before installation and operation of
the product.
•
Installation must fulfill local safety regulations.
•
Do not use adaptors or conversion adapters
with this product, according to IEC61851
standard requirements.
•
This charging station does not have ventilated
charging.
•
Make sure the cables in the charging station
are not loose due to vibrations during
transport. If any cables are loose, reconnect
the cables and tighten the screws.
•
The installation is recommended to be carried
out by two persons.
•
Use safety shoes during installation.
Tools
> 2000 mm
Mini-USB
CTEK E-Mobility AB
!
M8
•
Mifare Classic/IEC 14443 Type A and
compatible RFID tag (in case RFID shall be
used).
•
Computer/Laptop (OS: Linux or OSX is
recommended, Windows 10 requires USB
driver installation).
Optional equipment
•
Pole mount kit for a pole diameter of 60 mm.
Article number 920-00010 (only if added).
•
Pole mount kit for two boxes, to enable
maximum four EV connectors from one pole.
Article number 922-00018.
To check before installation
Do the checks that follow before you do the cable
installation.
1.
Avoid installation of the EV charger in direct
sunlight. If the product is installed in direct
sunlight, symbol visibility is decreased and the
temperature of the product increases. This will
trigger the overheating protection and limiting
the charging current.
2.
Decide if the unit should be installed outdoors
or indoors.
a
For outdoor installation, the power cable
and network cable are recommended to be
installed from below to prevent water from
entering the technical box from the top.
User & installation instructions
b.
For indoor installation, the power cable and
network cables can be installed either from
the top or from the bottom of the technical
box.
NOTE: For installations with a power cable
diameter greater that 17 mm, the power
cable must be installed from below.
To prepare the location for
installation
1.
Decide mounting position of the charging
station.
a.
Make sure that there is enough space
available for normal operation.
Min
Min
350 mm
300 mm
1100-
1500 mm
500-
12-24 kg
1500 mm
b.
For installation on a wall, make sure that the
wall material is suitable for mounting of the
box. The wall must withstand the weight of
the charging station.
c.
For installation on a pole, refer to the
manual for the pole mount kit.
To install the charging station on a
wall
246
43
[mm]
209.5
160
1.
Locate the four screw holes in the back cover.
2.
Drill four holes in the wall that align with the
holes in the back cover.
3.
Unlock and open the technical box with the key.
4.
Remove the protection cover.
5