CTEK CHARGESTORM CONNECTED 2 사용자 설명서 - 페이지 8

{카테고리_이름} CTEK CHARGESTORM CONNECTED 2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. CTEK CHARGESTORM CONNECTED 2 20 페이지.
CTEK CHARGESTORM CONNECTED 2에 대해서도 마찬가지입니다: 사용자 설명서 (19 페이지)

페이지 인쇄

To finish the installation

Carefully install the protection cover.

Close and lock the technical box with the key.

Put the cover on the key lock.

Turn on the power from the distribution panel.

NOTE: It may take one to two minutes for the charger

to start.

Make sure that the green connector symbol on the front panel activates.

To change the configuration settings

NOTE: For most installations no change of the configuration is needed.

NOTE: CTEK recommend that the installation technician documents the result of

the configuration tests in the dedicated protocol.

If the computer runs on Microsoft Windows, Download the CCU Drivers

from the webbsite. Follow the instructions given on the website.

NOTE: For Linux and Mac OSX, the USB driver is part of the operating system.

Connect the USB cable between the computer and the mini USB port on

the controller board.

User & installation instructions

Open the web browser and log in to the local web interface at

http://192.168.7.2

The user name and password are both "ccu".

NOTE: CTEK recommend web browser Google Chrome for this action.

To configure the network interface (Ethernet)

Navigate to Configuration>Interface>General and select WAN = Wire.

Navigate to Configuration>Interface.

Select Wire.

Select DHCP or Static. If Static is selected, also enter IP address, netmask

and gateway.

Press Save at the bottom of the page.

To configure WWAN (4G)

CTEK AB