Directed Video HRB100 소유자 설치 매뉴얼 - 페이지 8

{카테고리_이름} Directed Video HRB100에 대한 소유자 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Video HRB100 12 페이지. Directed video headrest monitor bucket owner's guide/installation guide

페이지 인쇄

Installation

The HRB100 mounting adapter allows secure

installation of the Directed Video RVM Series

Removable Monitors by installing the mounting

assembly into the vehicle headrest or seatbacks.

The HRB100 will accommodate the Directed Video

5.6", 6.8", and 7.0" monitors.

The HRB100 consists of two major pieces: the

receiver bracket and the headrest bucket.

Using the supplied template, center the

cut out area on the headrest or seatback

and mark the fabric area to be cut as indi-

cated. With a new razor knife, cut the fab-

ric as marked. Then cut the foam as indi-

cated on the template. Using the knife

remove as much of the foam padding as

necessary to allow clearance of the moni-

tor bucket.

WARNING! Be careful not to remove the headrest fab

ric past the line marked FABRIC CUT LINE.

If the fabric is removed past this line, the

headrest's inner foam may be visible after

the completed installation.

Once the headrest has been marked and

cut to accommodate the monitor bucket

the metal support bar around the inside of

the headrest will be noticeable. The mon-

itor bucket will be secured to this bar.

Run the supplied din cable through the

bottom of the headrest. Leave enough

slack in the cable so the headrest still has

full movement during adjustment.

Secure the headrest bucket by tying the

supplied zip ties through the mounting

feet and around the metal support bars.

The RVM Monitor locks into the receiver

bracket until physically released. The

release mechanism is in the rear of the

bracket.