Directed Video OHC100 소유자 설치 매뉴얼 - 페이지 7

{카테고리_이름} Directed Video OHC100에 대한 소유자 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Video OHC100 16 페이지. Directed video car video system user manual

페이지 인쇄

Basic Operation

MONITOR OPERATION

OPEN/CLOSE THE MONITOR DOOR

I I

To Open - Press the monitor door release

button (7); the monitor door will lower

into the viewing position.

I I

To Close - Place your hand on the bottom

center of the monitor door (3) and push it

upward into the video console until a click

is heard.

INSTALLING THE MONITOR

Open the monitor door to the viewing

position.

Hold the monitor with the top tilted away

from the monitor door, and then place the

bottom of the monitor into the two mount-

ing hooks at the bottom of th monitor door.

Push the top of the monitor toward the

monitor door until a distinctive click is

heard. the wiring connector at the rear of

the monitor is self guiding and will auto-

matically complete the connection.

REMOVING THE MONITOR

With the monitor door in the viewing

position, press the monitor release button

(1). At the same time, gently tilt the top of

the monitor away from the monitor door

then lift the monitor up and out of the

mounting hooks.

ADJUSTING THE VIEWING ANGLE

The viewing angle can be adjusted by sliding the

view angle adjuster from side to side.

Open the monitor door to its current

viewing angle.

Pull the bottom of the monitor door

toward the rear of the car and slide the

view angle adjuster all the way to the left,

then release the monitor door. The monitor

should now be at its maximum view angle.

Pull on the monitor door until it reaches

the desired view angle and hold it.

While still holding the monitor door, slide

the view angle adjuster to the right until

it stops. This will set the monitor door at

the desired view angle.

HP050 WIRELESS HEADPHONES

OPERATION

The headphones automatically turn on

when placed on your head.

Adjust the volume to the desired level

using the volume dial.

The headphones must be in line of sight of

the IR lens (10) on the OHC100 to receive

an audio signal.

BATTERY REPLACEMENT

Remove the slide door on the inside of the head-

phones to access the batteries. Replace with

standard AAA batteries making sure the batter-

ies are inserted according to the polarity marked

on inside of the headphone case.

DOME LIGHT OPERATION

If the OHC100 has a built-in dome light (8) that

can be used if the factory dome light must be

removed to accommodate the installation. The

built-in dome light has a three-position switch

(9) - OFF, DOOR, and ON.