Directed Video OHD1040 소유자 설치 매뉴얼 - 페이지 7

{카테고리_이름} Directed Video OHD1040에 대한 소유자 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Video OHD1040 20 페이지. 10.4” (4:3) overhead video monitor/dvd player

페이지 인쇄

6. Do not connect the yellow wire and red wire together of this product directly to the +12V. Connect

the red wire of this product to the ACC of the ignition key switch and yellow wire to +12V. Failure

to do so may result in permanent drainage of the battery charge.

7. Only supplied accessories should be used to avoid damage to the unit during installation.

8. Ensure that the display monitor is suitably installed at a location, such that it will not obstruct

the rear view mirror and/or the air condition vents.

9. Do not install this unit at a declining angle exceeding 30 degrees.

10. Do not install screws over the plane surface, which may affect monitor eject or retract function.

E E L L E E C C T T R R I I C C A A L L C C O O N N N N E E C C T T I I O O N N S S

P P o o w w e e r r C C a a b b l l e e ( ( 4 4 - - p p i i n n , , o o n n e e p p i i n n n n o o t t u u s s e e d d ) )

C C o o l l o o r r C C o o d d e e

Black

Red

Yellow

D D o o m m e e L L i i g g h h t t C C a a b b l l e e ( ( 5 5 - - p p i i n n ) )

C C o o l l o o r r C C o o d d e e

Black

Red

Yellow

Purple

Grey

The Red and Yellow wires should be connected together and then run to the domelight circuit.

This wire is the ground source for the monitor and DVD.

Accessory +12V switched power source for the monitor and DVD. This

wire supplies the main power to the system.

Constant +12V power. This wire supplies power to the DVD for last

position memory.

This wire supplies the ground to the domelight circuit.

This wire supplies +12V switched power to the domelight circuit.

This wire supplies +12V constant power to the domelight circuit.

This wire connects to the (+) door trigger.

This wire connects to the (-) door trigger.

F F u u n n c c t t i i o o n n