Clarke FOCUS L20 운영 매뉴얼 - 페이지 3
{카테고리_이름} Clarke FOCUS L20에 대한 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Clarke FOCUS L20 6 페이지.
페이지 인쇄MACHINE OPERATION (SCRUBBING/DRYING)
1.
Start the machine as shown in the previous paragraph.
2.
If necessary, press the washing water flow control switches
(A and B, Fig. 17) as necessary, depending on the type of
cleaning to be performed.
3.
If necessary, stop the machine and adjust the squeegee
with the knob (C) so that the rear blade (D) touches the floor
along all its length.
Machine drive controls
CAUTION!
These procedures must be performed by qualified
personnel or Clarke personnel only.
The machine speed and forward movement capability depends on
the floor type and on the choice of using brush or pad.
These can be adjusted by two screws (B and D, Fig.18), which
are on the brush plate, according to the following procedure:
–
Loosen the nut (A); when turning the adjusting screw (B)
counter-clockwise, the machine moves towards the left;
when turning it clockwise the machine moves towards the
right.
–
(Only for FOCUS II S20) loosen the nut (C); when turning the
adjusting screw (D) counter-clockwise, the machine speed
increases; when turning it clockwise the machine speed
decreases.
When the procedure is completed, tighten the nuts (A and/or C).
Clarke Focus Boost
Title
Figure 17
Figure 18
New
08/01/2013
Revision
Date
CT
Approved