CTEK D250SA 매뉴얼 - 페이지 4

{카테고리_이름} CTEK D250SA에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CTEK D250SA 13 페이지. 2 x 40a
CTEK D250SA에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (2 페이지), 사용자 설명서 (12 페이지)

INSTALLATION

1. Install the apparatus on a smooth surface where it can be fi rmly secured and where it is not

exposed to fuel, oil or dirt. To obtain the correct distance, start by fi tting the two units together with

the accompanying connector plate (see Figure 3) before they are fi nally fastened to the smooth

surface.

2. Secure the apparatus with, for example, M4 or ST4.2 screws at each corner (see Figure 1).

3. Before connecting the cables, ensure that the negative terminal post on the battery is not connected.

4. Connect the cables to the apparatus connections by securing screws (M8) (see Figure 2).

Use an Allen key - tightening by hand without a tool is not enough.

5. Use tape (see Figure 4) to secure the temperature sensor

to a clean ﬂ at surface above the service battery. Position the

sensor as close to the positive terminal post as possible.

6. Connect the battery negative terminal post.

WARNING!

The D250SA and SMARTPASS 120

are not protected against reversed

polarity. Disconnect the battery

terminal posts before installation.

Figure 1

2 Nm/18 lb-in

6 • EN

Figure 4

WARNING!

The D250SA and SMARTPASS 120

are not spark-free.

Ensure good ventilation.

8 Nm/71 lb-in

Figure 2

Allen key

Figure 3

168mm/6⅝ inches

250mm / 9,84inches