CTEK D250SA 빠른 시작 매뉴얼 - 페이지 2

{카테고리_이름} CTEK D250SA에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CTEK D250SA 2 페이지. 2 x 40a
CTEK D250SA에 대해서도 마찬가지입니다: 매뉴얼 (13 페이지), 사용자 설명서 (12 페이지)

Date: 2017-12-15

Version: 1.0

Starter battery:

Typically 55Ah to 100Ah for automotive applications.

A start battery should never be deeply discharged.

Service battery:

Size 40Ah to 600Ah. (2xD250SA)

When 20A with one D250SA gives to long recharge time

and alternator has a low voltage providing a low current

through SMARTPASS 120, a sulution is two parallel

connectet D250SA.

Batteries are connected in parallel to increase capacity

(Ah). Suitable deep cycle batteries should be used.

D250SA:

Install according to instruction manual.

Parallel connect two D250SA by connecting inputs with

each other and the same with the outputs.

Both unit must be connectet to ground.

Temperature sensor:

Attach the temperature sensor onto the service battery.

Title: 2 X D250SA 40A

Alternator:

If the alternator is a "smart alternator" that can adjust

voltage level by the engine control module or similar.

To get D250SA support a Smart alternator you connect

the Red Smart Alternator cable to the ingnition.

Charge voltage:

You can choose between 14.4V and 14.7V (AGM) on

D250SA.

If you not connect the Black AGM cable you get 14.4V

If you connect the Black AGM cable to minus you get

14.7V.

Fuses:

If fuses are used, mount the fuses as close to each

battery as possible.

Suitable fuse size:

2 X D250SA: 50A

Please verify directive for applicable installation

regarding fuses.

Wiring:

Please see instruction manual for suitable dimensions.

Please verify directive for applicable installation

regarding wiring.

A thick wire generate less voltage drop than a thinner

wire at high current.