Directed Video MCB1000 소유자 설치 매뉴얼 - 페이지 8
{카테고리_이름} Directed Video MCB1000에 대한 소유자 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Directed Video MCB1000 16 페이지. Video multi-control unit
페이지 인쇄Basic Operation
The RC100 can control the functions of the MCB
1000 zone monitors, the TVM300 TV tuner, the
VC2010 VCR, and the VC2050 VCR.
To operate a specific monitor, the remote con-
trols zone button (4) for that monitor must first
be selected.
TURN THE MCB1000 ON/OFF
I
Press the MAIN POWER (1) button to turn
the MCB1000 on/off.
TURN ZONE MONITORS ON/OFF
I
Press the ZONE (4) button for the monitor
you want to turn on.
I
Press the PWR/SOURCE (2) button to turn
the monitor on. Press the PWR/SOURCE
(2) button for more than three seconds to
turn the monitor off.
SELECTING A SOURCE
I
With the zone monitor on, press the
PWR/SOURCE (2) button for less than
three seconds to toggle through all
connected video sources.
PROGRAMMING MENU
I
All on-screen programming can be
performed using the MENU/ADJUST (5)
buttons.
Refer
Programming section for programming
information.
8
AUDIO THROUGH VEHICLE
SOUND SYSTEM
I
I
USING THE TV TUNER
MEMORIZING CHANNELS
I
CHANGING CHANNELS
I
NUMERIC BUTTONS
I
ANTENNA/CATV
I
to
the
On-screen
Only available with the RFM100 connected.
Select the zone that the RFM100 is
connected to. Press the FM MOD (3)
button. Set the vehicles radio to the
correct frequency and the audio from that
source will be heard through the vehicles
sound system.
With the TV tuner as the source, press the
CHDN/CHUP (7) buttons. The channel will
move up or down one channel at a time.
Press and hold to tune through channels at
a rapid rate.
With the TV tuner as the source, press the
AUTO MEM (8) button. The TV tuner will
start searching for stations, adding to
memory any channels within reception
range.
Channels can be directly selected by using
the Numeric (6) buttons. When the channel
number is selected, it will appear on the
screen for a few seconds then the TV tuner
will change to the selected channel.
When in an area where cable is available
the TVM300 can accept up to 125 channels
of CATV input. Refer to the programming
menu to change from Antenna to CATV.
© 2001 Directed Electronics, Inc.